Service-Ningbo Baichen Medical Devices Co., Ltd.

The surface of baking paint, spraying and plating parts should be smooth and even,with uniform color, and the decorative surface is not allowed to have obvious defects such as flow scars, pockmarks, blisters, cracks, wrinkles, peeling and scratches. Non decorative surfaces are not allowed to have exposed bottom and serious flow scars,cracks and other defects.

The surface of plastic parts should be flat, uniform color, no obvious flying edge, scratches, cracks, depressions and other defects.

Welded parts weld should be even and flat, without leakage, cracks, slag, burn through, bite edge and other defects.

Welded parts weld should be even and flat, without leakage, cracks, slag, burn through, bite edge and other defects.

All parts of the vehicle should be fully equipped, accurate and reliable.

All rotating parts should operate flexibly with appropriate clearance, and the vehicle's maneuvering mechanism should be light and flexible, and reset reliably.

Place the product on a platform with an inclination of 12°, the direction is facing uphill, and the vehicle cannot slide down when it stops at the ramp. Driving the product forward from a standstill should be no less than 5 m. If the vehicle stops during the driving process due to electrical or other reasons, it is considered that it cannot climb the ramp at that angle.

Maximum speed: ≤ 6.0 km/h.

Dimensions: seat width, seat height allowable error ± 5mm.

Labels need to be adhered with complete and clear information, the specific content according to customer requirements.

The carton is clean, firm and undamaged; the printing content is correct and clear.

Plastic bags are clean, firm and undamaged.

Complete configuration of accessories: manuals, accompanying tools, other required accessories.